v6.07 OBD2 DTC Code detection improved
v6.06 Fixed Oil Pressure readings, note must use the new formula for custom oil pid. The formula changed from (256*A+B-147)/10 to just A.
v6.03 Automatically switches MUT protocol and OBD2 protocol if connection fails.
v6.01 If the ECU protocol equals to OBD1, it will use 1st generation coolant table, otherwise it uses 2nd generation coolant table.
      Air intake temperature has been updated to match the factory scantool's.
V5.00 [BETA] All previous custom PIDS were hijacked by me and are now invalid, I have switched over to
      Mode22 custom pids which will remove some Torque clutter.  Low/Mid/High fuel trims now available.
v4.01 Added two more pressure sensors, generic 4.0 bar sensor, and Apexi 3.5 bar sensor.
v4.00 Major changes with the OBD2 style protocol (for 96-97 cars), most requests are now naitive OBD2 conversions instead of MUT over OBD2 conversions.
v3.20 Some things to keep in mind is that Mitsubishi fuel trims are not 100% the same as OBD2 style fuel trims. Mitsubishi has low, mid and high fuel trims.
      And with OBD1 cars, we only know of one bank, and we presume it's the rear bank. For the missing front bank, the rear bank data is re-used to
      satisfy the OBD2 request.

v3.00 Support error codes for 98/99 USA 3000GT ECU, including Chrome ECU.  It will automatically switch from MUT mode to OBD2 mode.
      Support error codes for 99 Euro ECU.
      Displays ECUID number now on main menu.
v2.01 For DOHC vehicles (non-turbo) defined code 62: VICS position sensor failure as code
      P2014 Intake Manifold Runner Position Sensor.
v1.16 Support for different microprocessor.
v1.15 Added count down delay when connecting to LCDBC unit.
V1.13 [Z]ero out Boost pressure sensor added to main menu.

V1.12 Repurposed PID 0x011E (Auxilary input status), so user can datalog fuel injector pulse.
      Mode and PID is 0x011E
      Equation A*256/100
      Min value = 0
      Max value = 65
      Units = ms   

V1.11 Repurposed PID 0x015B (Hybrid battery status), so user can datalog idle motor steps.
      Mode and PID is 0x015B
      Equation A
      Min value = 0
      Max value = 255
      Units = steps. 

v1.08 For 96-97 ECU owners that only have OBD2 MUT mode, a new option is available (Turbo OBD2 mode).
      This new mode offers 36% faster PID interaction between the Canbus converter and the ECU by ignoring
      the mandatory OBD2 delays.  With this faster interaction, you will notice improvement in the RPM, and
      other PID data.

v1.07 Fixed 91-93, 94-95 Permanent DTC codes.  I don't know the equivalent OBD2 error code for VICS MPS Circuit (62) so it's left blank.
v1.06 Special version for non-standard Mitsubishi cars
v1.05 Added more debugging information.
v1.04 Support for Oil temperature sensor -- must be installed on sensor 3 port.
      Oil temp sensor only reports ohms, and not voltage so a small addon circuit is required
      to convert it into a voltage.  See Oil Temp Schematics.png.

v1.03 Support for EVO vehicles.
v1.02 CEL or DTC code reading / clearing supported.
v0.99 First release.


